Installation Of The Lever; Installation Of The Shifting Cable - Shimano Nexus INTER 5E SG-C7000-5V Service Manual

„ Installation of the lever
Install the lever as shown in the illustration.
(A)
(C)
„ Installation of the shifting cable
For information on how to replace the inner cable, refer to the maintenance section.
(y)
(A)
Click here for the latest Dealer's Manual
https://si.shimano.com/DM/CASG002
Dealer's Manual
(SG-C7000-5V / SG-C7000-5R / SG-C7000-5C / SG-C7000-5D)
Attach the grip spacer to the lever and
pass it through the handlebar.
Attach the half grip.
(y)
Tighten the fixing bolt with a 3 mm
hexagon wrench.
(B)
(z)
(D)
(E)
Use a shifting cable with one inner cable
(z)
drum.
Shifting cable with one inner cable
drum:
OT-SP41
(y)
166 mm or more
(z)
Ø22.2 mm
(y)
Shifting lever side
(z)
Cassette joint side
Return to index page
(A)
Fixing bolt
(B)
Handlebar
(C)
3 mm hexagon wrench
(D)
Half grip
(E)
Grip spacer
Tightening torque
2 - 2.5 N·m
TECH TIPS
•
If using Shimano half grip, the straight
section of the handlebar should be 166 mm
or longer.
Attach the REVOSHIFT lever to this straight
section.
•
Leave a gap of 0.5 mm between the
REVOSHIFT lever and the half grip.
(A)
Sealed outer cap
NOTICE
Make sure that the sealed outer cap is at the
shifting lever end.
13