Replacing the Internal Assembly
Refer to the part breakdown (p. 78) for the names of parts.
1.
Hold the two beveled surfaces of
the hub axle on the brake arm side
in a vise and remove the dust cap.
2.
Remove the lock nut and stop nut.
(1) Secure the hub back into place with the
drive sidedownward.
(2) Use TL-7S20 to remove the nut.
3.
Remove the brake arm unit and
ball retainer from the hub axle.
Dust cap
•
Forcibly pulling it may cause damage
to the bracket cover because of its
material properties.
•
Do not damage the threads of the
Vise
hub axle.
TL-7S20
Locknut 17mm (Y-35P 28000)
Stop Nut 22mm (Y-35P 22000)
Brake arm unit
Return to index page
NOTICE
Ball retainer
51