Disassembly/Reassembly Procedures: Replacement Procedures
15. Remove the main board by sliding a finger into the provided opening at the front of the
chassis and gently pushing up on the 50-pin connector, lifting up the front of the PCB.
16. Then, slide the main board towards the front of the chassis. Swing it out of the chassis.
Handle the main board by the edges only, and store it in an antistatic bag.
17. Remove the J2 rear accessory connector by sliding it out of the chassis wall.
!
C a u t i o n
.
6871769L01-A
Figure 8-22. Pushing Up the Main Board
Do not attempt to remove the J2 accessory connector by
pulling on the flex. Doing so might damage the flex.
Figure 8-23. Removing the J2 Rear Accessory Connector
MAEPF-27683-O
J2 Rear Accessory
Connector
MAEPF-27785-O
October 30, 2006
8-17