Disassembly/Reassembly Procedures: Replacement Procedures
8.2.8
Radio Reassembly
8.2.8.1 Mid Power Models
Use the procedure that follows to reassemble your radio.
1. Prior to reassembling the radio, inspect all seals and sealing surfaces for damage (nicks,
cuts, etc.) or dirt. Refer to the exploded view bill of materials for the correct part numbers, and
replace parts, as necessary. Reseat all seals on their respective parts.
Begin with the chassis. Thoroughly inspect the chassis shield gasketing for damage and
verify all chassis thermal pads are in place and free of damage.
Replacement Procedure" on page 8-41
NOTE: T-shaped pad is only used on some models. Some models use thermal grease instead.
Figure 8-35. Inspecting the Chassis Shield Gasketing and Thermal Pads
6871769L01-A
to replace damaged pads.
Thermal
Pads
See "Chassis Thermal Pad
MAEPF-27685-O
October 30, 2006
8-25