Figure 8-46. Installing The Control Head Flex In The Transceiver; Figure 8-47. Installing The Headbridge On The Transceiver - Motorola ASTRO XTL 5000 Basic Service Manual

Disassembly/Reassembly Procedures: Replacement Procedures
13. Grasp the handle on the transceiver end of the control head flex, or TIB flex if remote, and
plug the flex into the 50-pin connector on the side of the main board.

Figure 8-46. Installing the control head Flex in the Transceiver

14. Hold the headbridge with one hand, and squeeze the center of the long span.
15. Align the headbridge with the transceiver, thread the flex through the headbridge, and push
the headbridge into place. You might hear a small snap as the alignment tabs engage. If the
headbridge does not align properly on the first try, do not try to slide it back and forth on the
transceiver. This will cause the seal to roll out of place. Instead, remove the headbridge and
try again, taking care to align it properly before fully seating it.
6871769L01-A

Figure 8-47. Installing the Headbridge on the Transceiver

8-33
October 30, 2006