8-4
4. Using a Torx T-8 screwdriver, remove the 5 printed circuit board (PCB) screws.
T-8 screw
5. Gently pull out the 2-pin connector which connect the back housing to the PCB.
October 30, 2006
Disassembly/Reassembly Procedures: Replacement Procedures
Figure 8-4. PCB Detachment
Hang-up stud
connector wire
Figure 8-5. Disconnecting the 2-pin Connector
T-8 screw
5
3
2
Hang-up stud
connector wire
2-PINS Connector
1
4
Main PCB Assembly
Back Housing
6871769L01-A