Basic Troubleshooting: Accessory Connectors
9.2.6
J400 CHUC - VIP and DEK Interface
J400 is located on the back of the O5 control head assembly in the remote mount configuration. This
connector provides the ability to utilize up to 3 VIP OUT, 3 VIP IN, the GND and SWB+ pins they
require, or DEK signal lines. This connector has cable detection pins to allow the control head to
determine which type of cable is being used, and therefore allow the control head to configure its
pins appropriately for either VIP or DEK accessory interfacing. It is not recommend to fabricate this
cable from scratch. The cable must be inserted prior to control head power-up. Please refer to the
installation manual for ordering part numbers for either the VIP or DEK cable.
the J400 connector while
Pin
No cable
1
SWB+
2
GND
3
no pin
4
Detect Pin 1
(Short to GND)
5
no pin
6
no pin
7
no pin
8
Detect Pin 2
(Short to GND)
9
Detect Pin 3
(Short to GND)
10
no pin
6871769L01-A
Table 9-6
describes the function of each pin.
Figure 9-6. J400 VIP and DEK Connector
Table 9-6. J400 VIP and DEK Connector Functionality
DEK cable
SWB+
GND
no pin
Detect Pin 1
(Short to GND)
STROBE
DATA-OUT
CLOCK
Detect Pin 2
(Short to SWB+)
Detect Pin 3
(Short to GND)
DATA-IN
VIP cable
Future cable
SWB+
SWB+
GND
GND
no pin
no pin
Detect Pin 1
Detect Pin 1
(Short to SWB+)
(Short to GND)
VIP_OUT_1
no pin
VIP_OUT_2
no pin
VIP_OUT_3
no pin
VIP_IN_1
Detect Pin 2
(Short to GND)
VIP_IN_2
Detect Pin 3
(Short to SWB+)
VIP_IN_3
no pin
Figure 9-6
illustrates
10
9
8
6
7
4
5
3
2
1
Future cable
SWB+
GND
no pin
Detect Pin 1
(Short to GND)
no pin
no pin
no pin
Detect Pin 2
(Short to SWB+)
Detect Pin 3
(Short to SWB+)
no pin
October 30, 2006
9-9