Kemlan Horizon 700 Low Line Installation Instructions Manual page 7

Installation Instructions Kemlan Three Sided Natural Draft
• Eyelets on the unit are supplied for attaching a turn buckle system,
6-8mm threaded rod is required with a nut and washer either side
of a sufficient supporting roof member. Alternatively, a stainless
steel wire with a minimum 1mm diameter or heavier and a
minimum break load of 130kg can also be used.
• Once hooks have been attached to the eyelets the turn buckle can
then be simply wound up to take the tension.
• Tighten the turn buckle until both the top and bottom glass runners
are parallel.
• Removable glass panel can now be placed in position allowing an
even gap between glass and underside of channel.
25/02/2021
Electronic Ignition Gas Fireplaces
THREADED ROD
MAKE SURE THESE
PLANES ARE PARALLEL,
AND MAKE SURE ALL
CORNERS ARE SQUARE
Ver. 1
DRILL THROUGH THE
BEAM , RAFTER OR
FRAMING IF REQUIRED
AND PUSH THROUGH
THE THREADED ROD.
EYELET
7