Table of Contents
Advertisement
About the "Presence sensor"
The product detects movement by people and pets,
and automatically controls the air volume. It predicts
house dust floating around and starts operation
before the air in the room becomes dirty.
(With "Air volume" setting to [Auto])
(Not all pets can be detected.)
Precautions during installation
Do not put the product in the following places:
Where the product will be exposed to direct
sunlight or direct blowing/heat of air conditioner.
(Otherwise, deformation, deterioration,
discoloration or malfunction may be caused.)
Near the window or where the humidity sensor
area is blocked.
(It may cause of the humidity sensor not operating
correctly.)
Where the wind from air outlet is directly applied to
furniture or wall.
(Stains may be caused.)
Near a TV set or radio.
(Otherwise, distortion or noises may be caused.)
Keep 1 m or more away from such devices. If
the power plug is inserted into the same outlet
as that of these devices, distortion or noises
may be caused. In this case, insert the power
plug into another outlet.
Operating conditions
Do not place any objects on the product.
(Otherwise, malfunction or failure may be
caused.)
Do not place magnets, metallic objects or similar
objects on the product.
(Otherwise the built-in magnet detects turnover
causing the check indicator to light up, which will
stop operation of the product.)
When there is a risk of freeze, please empty the
tank and tray.
(If the product operates with water frozen, failure
may be caused.)
4
Detection image
(It detects movement in the area in front of the product.)
It would be effective
if placed here!
Place it low on the floor as a countermeasure
against pollen.
Since pollen and dusts are likely to float in the air
near the floor, we recommend you put the
product on the flat floor in the room.
To circulate the air efficiently around in the
room.
To prevent the air inlet or the air outlet from being
blocked, install the product with its right, left and
the top about 30 cm or more away from walls or
furniture, curtains etc. To ensure efficient use of
the product, keep its back at least 1 cm away
from the wall.
When using the product in the same area for
extended periods of time
Using the product continuously in one location may
cause the wall, floor or other areas around the
product to become dirty due to the air sucked in at
the bottom of the product.
We recommend to move the product to a different
location occasionally or clean the wall, floor or other
areas regularly.
Advertisement
Table of Contents
