Computer Requirements - HP Jet Fusion 4200 Product Documentation Site Preparation Manual

Use hostnames or static IP addresses in devices and in the Command Center Server computer.
–
The computer in which Command Center Server is installed should always be on, awake, and
–
connected to the Internet.
● If your network performs SSL/TLS inspection, you must configure the Command Center software to
support SSL bump with the certificate provided by your IT department.
If your proxy requires authentication, you must configure the Command Center proxy tab with the
●
information supplied by your IT department.

Computer requirements

Command Center Server computer
HP recommends having only one computer running HP SmartStream3D Command Center Server. It should meet
these requirements:
24/7 uptime (it never switches off or goes to sleep)
●
● 24/7 access to the HP Cloud
Local network access to all HP 3D devices
●
Intel Core processor with four virtual cores/threads
●
Computer running Windows 10 (64-bit) or Windows Server 2012 R2
●
● 8 GB RAM
400 GB available hard disk space
●
Command Center Client computers
Bear in mind that you can run this software in as many computers as required.
Each of the computers running HP SmartStream 3D Command Center Client should meet these requirements:
Local network access to the computer running HP SmartStream 3D Command Center Server
●
NOTE:
Intel Core processor with four virtual cores/threads
●
● Computer running Windows 10 (64-bit) or Windows Server 2012 R2
8 GB RAM
●
400 GB available hard disk space
●
Local network
The local network(s) interconnecting the computers running HP SmartStream 3D Command Center and the
printers must meet the following requirements:
Ethernet (IPv4) connection, at least 100 MB/s
●
40 Chapter 4 Plan your computer and network environment
No connection to any printer is required.
ENWW