Designing The Optimal Print-Production Area - HP Jet Fusion 4200 Product Documentation Site Preparation Manual

Hide thumbs

Table Of Contents

Table of Contents

ESD-free

●

Floor leakage resistance should be below 100 MΩ.

In many factory environments the conventional flooring materials, such as bare concrete or steel grids, are

adequately conductive.

In order to remain effective, the floor should not be covered by insulating paint, rubber mats, or plastic

sheets; care should be taken to prevent the build-up of contaminants such as resin or other insulating

substances; and its resistance should be regularly checked.

Easy to clean

●

Durable

●

Non-combustible

●

Free from floor vibration: for example, floor vibration is likely near a railway station, press machine room,

construction site, or heavy industry. If such vibration cannot be avoided, suitable floor preconditioning to

mitigate vibration may be needed for optimal printer performance.

NOTE:

The floor surface over which the build unit will move between the printer and the processing station

should have the same characteristics: it should be horizontal, free of steps, holes, and indentations, smooth to

avoid transport vibrations, and far from any obstacle that might cause accidental shocks. It is vital to avoid

damage to the contents of the build unit, both when it is full of fresh material and also after printing. Move the

build unit slowly and with care.