Wheel Bearings Inspection - Triumph Speed Triple 1200 RS Owner's Handbook Manual

Note
Always inspect the wheel bearings at
the same time as the steering bearings.
Inspecting the Steering for Free Play
To inspect the steering:
• Lubricate and inspect the condition
of the steering (headstock) bearings
in accordance
maintenance requirements.
• Position the motorcycle on level
ground, in an upright position.
• Raise the front wheel above the
ground and support the motorcycle.
• Standing at
motorcycle, hold the lower end of
the front forks and try to move
them forwards and backwards.
• If any free play can be detected in
the steering (headstock) bearings,
ask your authorised Triumph dealer
to inspect and rectify any faults
before riding.
• Remove the support and place the
motorcycle on the side stand.
with scheduled
the front of

Wheel Bearings Inspection

Operation with worn or damaged front
or rear wheel bearings is dangerous
and may cause impaired handling and
instability leading to an accident. If in
doubt, have the motorcycle inspected
by an
before riding.
If the wheel bearings in the front or
rear wheel allow play in the wheel hub,
are noisy, or if the wheel does not turn
smoothly, have your authorised Triumph
dealer inspect the wheel bearings.
The wheel bearings must be inspected
at the
scheduled maintenance chart.
To inspect the wheel bearings:
• Position the motorcycle on level
ground, in an upright position.
• Raise the front wheel above the
ground and support the motorcycle.
the • Standing
motorcycle, gently rock the top of
the front wheel from side to side.
• If any free play can be detected, ask
your authorised Triumph dealer to
inspect and rectify any faults before
riding.
• Reposition the lifting device and
repeat the procedure for the rear
wheel.
• Remove the support and place the
motorcycle on the side stand.
Maintenance
Warning
authorised Triumph
intervals specified
at the side
dealer
in the
of the
129