Triumph Speed Triple 1200 RS Owner's Handbook Manual page 111

• Fit the oil filter cover with the wire
guide in the same orientation noted
for removal. Tighten the fixing to
3 Nm.
• Attach the
connector to the oil filter cover.
• Route the harnesses and hoses
through the wire guide as noted for
removal.
3
7
6
B01551
1. Side stand switch connector
2. Fixing
3. Cover
4. Wire guide
5. Engine subharness
6. Fuel tank drain hose
7. Coolant expansion tank drain hose
• Position the
the crankcase with the coolant
expansion tank hose, fuel tank
vent hoses and the oxygen sensor
harness positioned as noted for
removal.
• Note the lower left hand fixing also
secures the oil filter cover between
the sprocket cover and crankcase.
side stand switch
5
4
2
1
sprocket cover
• Fit and tighten the fixings to 10 Nm.
2
B01301
1. Sprocket cover
2. Fixings
• Fit the TSA shift force sensor upper
ball socket to the gear change
knuckle ball joint and secure with
the wire clip.
to
B01552
1. Wire clip
2. TSA shift force sensor
• Start the engine and allow it to idle
for a minimum of 30 seconds.
Maintenance
1
1
2
111