Triumph Speed Triple 1200 RS Owner's Handbook Manual page 167

Hide thumbs Also See for Speed Triple 1200 RS:
Table of Contents

Advertisement

Set the motorcycle on a stand so
that both wheels are raised off the
ground. (If this cannot be done, put
boards under the front and rear
wheels to keep dampness away
from the tyres).
Spray rust inhibiting oil (there are
numerous products on the market
and your dealer will be able to offer
you local advice) on all unpainted
metal surfaces to prevent rusting.
Prevent oil from getting on rubber
parts, brake discs or in the brake
calipers.
Lubricate and if necessary adjust
the drive chain (see page 118).
Make sure the cooling system is
filled with a 50% mixture of coolant
(noting
that
coolant, as supplied by Triumph, is
pre-mixed and requires no dilution)
and distilled water solution (see
page 113).
Remove the battery, and store it
where it will not be exposed to
direct sunlight, moisture, or freezing
temperatures.
should be given a slow charge (one
Ampere or less) about once every
two weeks (see page 143).
Store the motorcycle in a cool,
dry area, away from sunlight, and
with a minimum daily temperature
variation.
Put a suitable porous cover over the
motorcycle to keep dust and dirt
from collecting on it. Avoid using
plastic or similar non-breathable,
coated materials that restrict air
flow and allow heat and moisture to
accumulate.
HD4X
Hybrid
OAT
During
storage
Cleaning and Storage
Preparation after Storage
To prepare the motorcycle to be ridden
after storage, do the following:
Install the battery (if removed) (see
page 145).
If the motorcycle has been stored
for more than four months, change
the engine oil (see page 108).
Check all the points listed in the
Daily Safety Checks section.
Before starting the engine, remove
the spark plugs from each cylinder.
Put the side stand down.
Crank the engine on the starter
motor several times.
Refit the spark plugs, tightening to
12 Nm, and start the engine.
Check and if necessary correct the
tyre pressures (see the relevant
Specification section).
Clean the entire vehicle thoroughly.
Check
operation.
Test ride the motorcycle at low
it
speeds.
the
brakes
for
correct
167

Advertisement

Table of Contents
loading

Table of Contents