Storing And Recalling Data - PCE Health and Fitness PCE-TUM 50 Instruction Manual

Selecting the TSS measurement mode
6.1 Press and hold the key for 3 seconds to enter the setup menu.
Press the ◄ or ► key to select the "Measurement Mode", press the
6.2
Press the ◄ or ► key to select "mg/L (TSS)", press the
6.3
TSS measurement
The measurement method is the same as the turbidity. Please refer to page 10 "Turbidity Measurement".

Storing and Recalling Data

The PCE-TUM 50 turbidity meter is capable of storing and recalling up to 200 data sets.
Storing readings into memory
During the measurement process, press the
Viewing stored readings
MR
1. Press the key in the measurement mode, the meter shows the stored data.
If necessary, press the ◄ or ► key to view the data log.
2.
ESC
3. Press the key, the meter returns to the measurement mode.
Enter
key. The meter enters the Total Suspended Solids measurement mode.
MI
key to store the reading into the memory. The display will show "Data is stored in memory".
Enter
key to confirm.
11