Table of Contents
Advertisement
Operation
Mode
Totem Mode
Sensitivity
Setup
(cont.)
USB Set
Running Mode:
Sys Info
DMX Address:
Temperature:
Configuration (DMX)
The Intimidator Beam Q60 works with a DMX controller. Information about DMX is in the CHAUVET DMX
Primer, which is available from the Chauvet website
DMX_Primer_rev05_WO.pdf.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If you choose a starting address that is too high, you could restrict the access to some of the
product's channels.
The Intimidator Beam Q60 uses up to 16 DMX channels, which defines the highest configurable address
to 497.
If you are not familiar with the DMX protocol, download the DMX Primer from www.chauvetdj.com.
To select the starting address, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Address.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select the starting address, from 001–501.
5. Press <ENTER>.
DMX Personalities
The Intimidator Beam Q60 has two DMX personalities, a 16-channel personality, and a 12-channel
personality.
To choose which DMX personality to use, follow the steps below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select DMX.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select the DMX personality, from 16CH or 12CH.
7. Press <ENTER>.
Intimidator Beam Q60 User Manual Rev. 1
Programming Levels
OFF
UP
DOWN
001–100
OFF
ON
Reset
Factory Set
Ver:
_ _ _ _ _ _ _ Displays the current running mode
_ _ _
_ _ C
Description
Normal mode
Totem mode Base Up
Totem mode Base Down
Sets the sound sensitivity
Enables or disables USB function
Resets the product
Loads factory defaults
V_
Displays the firmware version
Displays the current DMX address
Displays the product temperature in °C
http://www.chauvetlighting.com/downloads/
Page 7 of 19
Advertisement
Table of Contents
