Table of Contents
Advertisement
USB Set
To enable or disable the USB update function, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select USB Set.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (disabled) or ON (enabled).
7. Press <ENTER>.
Reset
To reset all functions on the Intimidator Beam Q60, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Reset.
5. Press <ENTER>.
Factory Reset
To restore the Intimidator Beam Q60 to factory default settings, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Factory Set.
5. Press <ENTER>.
System Information
To view the system information on the Intimidator Beam Q60, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Sys Info.
3. Press <ENTER>
Master/Slave Mode
The Master/Slave mode allows a single Intimidator Beam Q60 product (the "master") to control the actions
of one or more Intimidator Beam Q60 products (the "slaves") without the need of a DMX controller. The
master product will be set to operate in standalone mode, while the slave products will be set to operate in
slave mode. Once set and connected, the slave products will operate in unison with the master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Slave.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from Slave1, Slave2, Slave3, or Slave4.
•
Select Slave1 for 100% synchronized actions.
•
Select Slave2, Slave3, and/or Slave4 for delayed actions, creating a wave effect.
7. Press <ENTER>.
8. Connect the DMX input of the first slave product to the DMX output of the master product.
9. Connect the DMX input of the subsequent slave products to the DMX output of the previous slave
product.
10. Finish setting and connecting all the slave products.
Master product:
1. Set the master product to operate in standalone mode.
2. Make the master product the first product in the DMX daisy chain.
•
Configure all the slave products before connecting the master to the daisy chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave operation
because the controller may interfere with the signals from the master.
•
Do not connect more than 31 slaves to the master.
Page 14 of 19
Intimidator Beam Q60 User Manual Rev. 1
Operation
Advertisement
Table of Contents
