IBM 3454-FCE Customer Install Manual page 41

Figure 17. Disengaging the circuit breakers and aligning the connector on the
power cord with the PDU model
(L001)
6. Route the power cord from the PDU model toward the rack side braces.
Then, route the power cord along a side brace toward the rear of the rack and
secure the power cord with the cable straps that are provided with the PDU
model.
7. Route the power cord toward a dedicated power source.
Use the provided cable straps to secure the power cord along the way. Use the
openings in the rack, if the power cord must exit the rack to connect to a power
source.
Attention To prevent damage to a power device and other connected devices,
always connect the power device to an authorized power source for that device.
© Copyright IBM Corporation 2020. Customer Install Guide, PDU 41