To Park The Product; To Stop The Product; To Switch Off The Product; To Charge The Battery - Husqvarna AUTOMOWER 420 Operator's Manual

4.3.4 Spot cutting
Spot cutting to cut a selected
Use the operating mode
area in a spiral pattern. You must move the product
manually to the selected area before you start the
cutting operating mode.
Note:
After the product has operated in the operating
Spot cutting , it will automatically start to cut in the
mode
Main area or Secondary area .
operating mode

4.4 To park the product

1. Push the STOP button to open the hatch.
2. Set the Main switch to position 0.
3. Enter the PIN code.
4. Push the PARK button.
5. Select an operating mode. Refer to
modes - Park on page 35 .
6. Push the OK button.
7. Close the hatch.
4.4.1 Operating modes - Park
Park until further notice
•
Start with schedule
•
4.4.1.1 Park until further notice
Use the operating mode Park until further notice for the
product to go back to the charging station. The product
will stay in the charging station until you select a new
operating mode.
4.4.1.2 Start again with next schedule
Start again with next schedule
Use the operating mode
for the product to go back to the charging station. The
product will stay in the charging station until the next
Schedule setting.

4.5 To stop the product

1. Push the STOP button to make the product and
the cutting motor stop.

4.6 To switch off the product

1. Push the STOP button on top of the product.
2. Set the Main switch to position
1201 - 005 - 19.03.2021
Spot

4.7 To charge the battery

Operating
When the product is new or has been stored for a long
period, the battery can be empty and needs to be
charged before starting. In the
product automatically alternates between mowing and
charging.
1.
2.
3.
0 .
WARNING:
Only charge the product
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
Main area mode, the
Set the Main switch to position
Place the product in the charging station. Slide the
product in as far as possible to ensure proper
contact between the product and the charging
station. Refer to contact and charging plates in
Product overview on page 4
The display shows a message that charging is in
progress.
1 .
Operation - 35