Husqvarna AUTOMOWER 420 Operator's Manual page 13

the charging station and the power supply may
occur and create a potential risk of fire.
• The product may only be operated, maintained and
repaired by persons that are fully conversant with
its special characteristics and safety regulations.
Please read the Operator's Manual carefully and
make sure you understand the instructions before
using the product.
• It is not permitted to modify the original design of
the product. All modifications are made at your
own risk.
• Check that there are no foreign objects such as
stones, branches, tools or toys on the lawn. If the
blades hit foreign objects the blades can be
damaged. Always switch off the product with the
main switch before clearing a blockage. Inspect
the product for damage before staring the product
again.
• If the product starts to vibrate abnormally, switch
off the product with the main switch. Examine the
product for damages before you start the product
again.
• Start the product according to the instructions.
When the product is switched on, make sure to
keep your hands and feet away from the rotating
blades. Never put your hands and feet under the
product.
• Never touch moving hazardous parts, such as the
blade disc, before it has come to a complete stop.
• Never lift up the product or carry it around when it
is switched on.
• Do not let persons who do not know how the
product works and behaves use it.
• The product must never be allowed to collide with
persons or other living creatures. If a person or
other living creature comes in the product's way it
shall be stopped immediately. Refer to
product on page 35 .
• Do not put anything on top of the product or its
charging station.
• Do not allow the product to be used with a
defective guard, blade disc or body. Neither should
it be used with defective blades, screws, nuts or
cables. Never connect a damaged cable, or touch
a damaged cable before it is disconnected from
the supply.
1201 - 005 - 19.03.2021
• Do not use the product if the Main switch does not
work.
• Always switch off the product using the Main
switch when the product is not in use. The product
can only start when the Main switch has been
switched on and the correct PIN code has been
entered.
• Husqvarna
between the product and other types of wireless
systems such as remote controls, radio
transmitters, hearing loops, underground electric
animal fencing or similar.
• Metal objects in the ground (for example reinforced
concrete or anti-mole nets) can result in a
stoppage. The metal objects can cause
interference with the loop signal which then can
lead to a stoppage.
• Operation and storage temperature is 0-50 °C /
32-122 °F. Temperature range for charging is 0-45
°C / 32-113 °F. Too high temperatures might cause
damage to the product.
2.3.2 Battery safety
WARNING:
explode or cause fire if disassembled, short-
circuited, exposed to water, fire, or high
temperatures. Handle carefully, do not
dismantle, open the battery or use any type
of electrical/mechanical abuse. Avoid
storage in direct sunlight.
For more information about the battery, refer to
on page 37
2.3.3 How to lift and move the product
WARNING:
switched off before lifting it. The product is
disabled when the Main switch is in position
0 .
CAUTION:
it is parked in the charging station. It can
damage the charging station and/or the
product. Push STOP and pull the product
out of the charging station before lifting it.
To stop the
To safely move from or within the work area:
1. Push the STOP button to stop the product.
®
does not guarantee full compatibility
Lithium-ion batteries can
The product must be
Do not lift the product when
Battery
Safety - 13