Husqvarna AUTOMOWER 420 Operator's Manual page 14

Hide thumbs Also See for AUTOMOWER 420:
Table of Contents

Advertisement

2.
Set the main switch in position
3.
Carry the product by the handle with the blade disc
away from the body.
2.3.4 Maintenance
WARNING:
switched off before any maintenance is
done. Use the plug to disconnect the
charging station before any cleaning or
maintenance of the charging station or the
loop wire.
WARNING:
the charging station before any cleaning or
maintenance of the charging station or the
loop wire.
14 - Safety
0 .
The product must be
Use the plug to disconnect
CAUTION:
Never use a high-pressure
washer or even running water to clean the
product. Never use solvents for cleaning.
Inspect the product weekly and replace any damaged or
Maintenance on page 36 .
worn parts. Refer to
2.3.5 In the event of a thunderstorm
To reduce the risk of damage to electrical components
in the product and the charging station, we recommend
that all connections to the charging station are
disconnected (power supply, boundary wire and guide
wire) if there is a risk of a thunderstorm.
1.
Mark the wires to simplify reconnecting. The
charging station's connections are marked AR, AL
and G1/G2/G3.
2.
Disconnect all connected wires and the power
supply.
3.
Connect all the wires and the power supply if there
is no longer a risk of thunder. It is important that
each wire is connected to the right place.
1201 - 005 - 19.03.2021

Advertisement

Table of Contents
loading

This manual is also suitable for:

Automower 430xAutomower 440Automower 450x

Table of Contents