Husqvarna AUTOMOWER 420 Operator's Manual page 19

0 cm / 0"
3.4.3.4 To make a secondary area
Make a secondary area (B) if the work area has 2 areas
that are not connected with a passage. The work area
with the charging station is the main area (A).
Note:
The product must be manually moved between
the main area and the secondary area.
B
A
• Put the boundary wire around the secondary area
(B) to make an island. Refer to
on page 18 .
Note:
The boundary wire must be put as 1 loop
around all of the work area (A + B).
Note:
When the product cuts grass in the
Secondary area mode must
secondary area, the
Secondary area on page
be selected. Refer to
34 .
1201 - 005 - 19.03.2021
3.4.4 To examine where to put the guide
wire
•
•
•
•
•
3.4.5 Work area examples
•
To make an island
•
•
•
Put the guide wire in a line at a minimum of 2 m /
6.5 ft. in front of the charging station.
Make as much free area as possible to the left of
the guide wire when facing the charging station.
Refer to Corridor width on page 29 .
Put the guide wire minimum 30 cm / 12 in. from the
boundary wire.
Do not make sharp bends when you install the
guide wire.
135º
135º
If the work area has a slope, put the guide wire
diagonally across the slope.
If the charging station is put in a small area (A),
make sure that the distance to the boundary wire is
at a minimum 3 m / 10 ft. in front of the charging
station.
If the work area has a passage (B) with no guide
wire installed, the recommended minimum
distance between the boundary wires is 2 m / 6.5
ft. With a guide wire installed through the passage,
the recommended minimum distance between the
boundary wires is 60 cm / 24 in.
If the work area has areas which are connected by
a narrow passage (B), you can set the product to
first follow and then leave the guide wire after a
certain distance (C). The settings can be changed
Lawn Coverage on page 27 .
in
Use the GPS Assisted Navigation that helps the
product select the most optimal operation. Refer to
To set the GPS Assisted Navigation on page 27 .
90º
Installation - 19