Daikin Trailblazer AGZ030E-070E Installation, Operation And Maintenance Manual page 121

Table 83: LONWORKS Network Parameters
Parameter Value (Range)/Definition
Option A [3]/During initial pow er-up, the frequency converter automatically
8-02 Control Source sets this parameter to Option A [3] if it detects a valid fieldbus option
installed in slot A
11-0 Neuron ID Variable/This is the neuron ID of the Lonw orks module.
11-10 Drive Profile VSD Profile [0]/This parameter indicates the LONMARK functional profile
(0-FFFF)/This parameter contains LON specific w arnings.
Bit
0
1
2
3
4
5
6
11-15 LON
Warning Word
7
8
9
10
11
12
13
14
15
0 N/A/This parameter contains the version of the external interface file on
11-17 XIF Revision
the Neuron C chip on the LON option
11-18 LonWorks 0 N/A/This parameter contains the softw are version off the application
Revision program on the Neuron C chip on the LON option.
11-21 Store Data Off [0] or Store all setups [2]/This parameter is used to activate storing of
Values data in non-volatile memory.
Table 84: MS Service LED - Red
Situation
Configured state (normal operation) ½ sec. ON, then continuously OFF
Non-configured state
Applicationless state
Watchdog resets
Faulty hardware
www.DaikinApplied.com
Status
Internal Fault
Internal Fault
Internal Fault
Internal Fault
Internal Fault
Reserved
Reserved
Reserved
Reserved
Invalid type change for changeable types
Initialization error
Internal communication error
Software revision mismatch
Bus not active
Option not present
LON input (nvi/nci) exceeds limits
LED Activity
Flashing ½ Hz
1 sec. ON, 2 sec. OFF, then
continuously ON
Short flash about each 3 sec.
Steady ON or OFF
121
BAS Integration of Pumps
Default Value
FC Port [1]
Variable/This item w ill be blank if the
communication module is not commissioned.
VSD Profile [0]
N/A
0 N/A
0 N/A
When activated (set to [2] Store all setups), all
parameters are stored in EEPROM; the value
returns to [2] Off w hen all parameter values
have been stored.
Description
The node is configures and running normally.
Node is not configures but has an application.
Proceed w ith loading node.
Node has no application, the LonWorks option
needs replacing or reprogramming
Indicates problem w ith application. The
LonWorks option needs replacing.
The LonWorks option needs replacing.
IOM 1207-6 • TRAILBLAZER MODEL AGZ CHILLERS
®