Table of Contents
Advertisement
Figure 4 24V Power Connector
1.8
Software Startup
On the desktop of your control, there is a Mach4 shortcut for your machine type. Below is an example of the Mach4
shortcut.
Figure 5 Profiles
There is also a shortcut for Mach4 Loader. This allows any of the profiles to be loaded from one location. Double
clicking on the Mach4 Loader shortcut opens the following window:
Figure 6 Loader
After double clicking on a profile or opening a profile from Mach4 Loader, a window will come up (Figure 7) asking to
Press Cycle Start to Enable Mach and Home All Axes . Select [Cancel] since motion is not yet possible.
Figure 7 Enable and Home All axes
Advertisement
Table of Contents
