Table of Contents
Advertisement
The Machine Parameters tab contains custom options for the control, including dialogue options, lube system, tool
measurement/offsets, and tool changer options.
7.1.1
Lube System Setup
The system may require an oiler. Enable the lube system, choose an action trigger, set the lube output, set the time
run time of the oiler, and the time between cycles. In the example below the lube output will turn on when the spindle
is running for 10 seconds every 15 minutes.
Figure 40 Lube System Setup
7.1.2
Tool Setter Setup
Tool setter configuration has been updated as of 9/21/18. If you purchased your system after this date than Use the
"Tool Setter Wizard". Otherwise, skip that section and follow steps for older builds of Mach.
Tool Setter Wizard: To start, make sure you are in unlocked mode.
Figure 39 - MachMotion Plugin Options
Advertisement
Table of Contents
