Table of Contents
Advertisement
Under "Tool Offsets" click the "Config Setters" button.
You can then add and configure setters. You can have multiple tool setters, both manual and auto.
Auto tool setters use a "Probe input". G31, G31.1 ect. Configure this in the Input Signals section under Probe(G31),
Probe 1(G31.1) ect.
To add a new setter, press "Add new" and then fill out the options and run through the Height and Z position Wizards.
Traditional Setup:
Before you measure tool to setup your tool table, the tool setter options must first be defined. Begin by going to
Advertisement
Table of Contents
