Table of Contents
Advertisement
the example below.
Figure 32 Standard NPN Proxy
If the proxy has an internal pull-up resistor, depending on its size, it could require the jumper to be completely
removed. Use a 3.9k ohm resistor and connect it between XSL and C0+.
Below is an example of a 24V NPN proxy with an internal pull-up resistor. The jumper on the Apollo III must be
completely removed for this to work.
Figure 33 NPN Proxy with Internal Pullup
5.2.3
Sourcing Inputs (PNP)
For PNP proxies place the jumper on the bottom two pins. Then connect the signal into the corresponding input.
Figure 34 24V Proxy Example
5.3
Configuring Inputs
1. On the menu bar click on Configure->Control. Then select the Input Signals
Advertisement
Table of Contents
