Arcconf Setalarm; Arcconf Setcache - Adaptec ICP5045BL User Manual

Parameters
Controller# is the controller number
BaseName is the name of the ROM image basename or the fully qualified name if you have a
set of controller ROM images.
Note:
All UFI files must be in the same directory prior to invoking ARCCONF. If you are copying
UFI files from floppy images, be sure to check all images.
Example
ARCCONF ROMUPDATE 1 AC2200
ARCCONF ROMUPDATE 1 AC220001.UFI

arcconf setalarm

Sets the state of the controller audible alarm, if present.
Syntax
ARCCONF SETALARM <Controller#> <on|off|silence|test>
Parameters
Controller# is the controller number
On enables the alarm
Off disables the alarm
Silence quiets the currently sounding alarm
Test triggers the alarm
Example
ARCCONF SETALARM 1 TEST
ARCCONF SETALARM 1 SILENCE

arcconf setcache

Changes a logical drive's cache mode.
Syntax
ARCCONF SETCACHE <Controller#> LOGICALDRIVE <LogicalDrive#> <cache mode>
[noprompt]
SETCACHE <Controller#> DEVICE <CHANNEL# ID#> <cache mode>
Parameters
Controller# is the controller number
LogicalDrive# is the number of the logical drive whose cache will be altered
Logical drive cache modes:
RON - read cache on
●
ROFF - read cache off
●
WT - write through disabled
●
WB - write back enabled
●
WBB - write back battery enabled (when protected by a battery)
●
Channel/ID lists the space-delimited channel number and device number pairs for each device
to add to the logical drive.
Chapter 2: Using the Command Line Utility
19
●