Table of Contents
Advertisement
Manual Set-up (without Remote)
MANUAL
PUSH-BUTTONS
Manual Set-up (without Remote)
Ultraview US23-0640-09
© Copyright 2009 Besam US Inc. May not be reprinted without permission
In addition to the remote control, set-up of the parameters of the Ultraview may be done by
using the two sensor-mounted push buttons. The procedures below indicate how to program
using these buttons.
TO RESET THE UNIT TO FACTORY DEFAULTS including the access code
Press and hold both buttons simultaneously until both red and green
LED lights flash alternately.
TO ENTER INTO MANUAL SET-UP MODE
Press the right button for 3 seconds and release.
The LED will flash red, then green a number of times.
To return to standard mode:
Press the right button again for 3 seconds
until the LED light stops flashing and then release.
TO CHANGE PARAMETERS
The red LED light indicates the number for the parameter being altered
( 1 flash = parameter #1).
The green LED light indicates the value for the parameter being altered
( 1 flash means value = 1).
The right button enables selection of the parameter number being altered
( +1 for each press).
The left button enables alteration of the value
( +1 for each press).
Parameter Number
(altered by the right button
and confirmed by RED LED)
1
4
5
11
14
EXAMPLE:Change radar sensitivity from 7 to 9 :
1.Press the right button for 3 seconds to enter the customizing mode
The green LED flashes once (parameter 1)
The red LED flashes 7 times (sensitivity = 7)
Press the left button twice to move from sensitivity = 7 to sensitivity = 9
Press the right button for 3 seconds to leave the customizing mode
NOTE:
1.When the highest value for the parameter has been reached, the
value will "roll over" to its lowest value
(e.g. for detection mode: 1, 2, 3, then 1, 2, ...).
2.The sensor automatically returns to standard mode if neither button
has been pressed for one minute.
Parameter
Radar Sensitivity
Automatic Learn Time
Detection Mode
Re-entry Zone
Door control function
07-30-09
Values
(altered by the left button and
confirmed by GREEN LED)
0-9
0-9
1-3
0-9
1-3
1 0
Default Value
7
0
3
3
1
V4
Advertisement
Table of Contents
