Table of Contents
Advertisement
Planned Maintenance Checklist
To perform a proper Planned Maintenance inspection, you must follow the checklist below. Please
use your service tickets to note that this was done and record any
problems discovered and the action(s) taken.
Besam US Inc.
1900 Airport Road
Monroe, NC 28110
Tel: (704) 290-5551, Fax: (704) 290-5555
Ultraview US23-0640-09
© Copyright 2009 Besam US Inc. May not be reprinted without permission
1.Visually inspect door operation.
2.Check activation and threshold detection devices.
3.Check for tripping hazards.
4.Check door function switch.
5.Check for proper operation of lock assembly.
6.Check for required signage.
7.Check for loose glass stops or damaged glass.
8.Check all panels for damage and missing or damaged weather stripping.
9.Check panic latches for proper release force.
10.Check panic circuit operation for operator cut off or spring return.
11.Clean and inspect bottom guide tracks.
12.Check bottom guide assembly for proper adjustment and excessive wear.
13.Check door closing speed and closing force.
14.Check closing latch location.
15.Check that door hold open time is 1.5 seconds or longer.
16.Remove access cover and check motor and gearbox for leakage and noise.
17.Inspect drive pulleys and belt for proper alignment.
18.Inspect drive belt for proper tension and excessive wear.
19.Clean hanger rollers and repair or replace if damaged. Adjust roller height if necessary.
20.Clean roller track and remove any debris. (Do not lubricate track).
21.Inspect anti-riser block or rollers for damage and/or binding.
22.Insure that all wiring in the header is properly routed and protected from any
moving components.
23.Re-install and secure access cover and re-check the complete door operation.
24.Clean door, glass and header thoroughly.
25.Note on the Planned Maintenance review any recommendations to improve
door performance and reliability, and review with customer.
07-30-09
1 6
V4
Advertisement
Table of Contents
