Table of Contents
Advertisement
Troubleshooting
Error
Description
10
NV-RAM Error
11
Position Error
12
Homing Error
14
Illegal Position
5-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Error Messages
If an error message appears on the VALVEMATE,
refer to the following table.
Solution
There is a problem in the VALVEMATE software. Reset its
parameters by turning OFF power. Then hold down the
MODE key while turning ON power.
The VALVEMATE is having difficulty rotating the valve. Try
replacing the valve seal. Refer to the instruction sheet
supplied with the valve.
The VALVEMATE cannot home the valve. Ensure that the
appropriate valve is selected in the VALVEMATE software.
Check that the valve is secure within the coupling and, if
necessary, tighten the internal coupling screws via the side
panel and tighten the front-panel thumbscrew. Turn power
OFF then ON to the VALVEMATE.
The VALVEMATE received a GSIOC command or input
signal instructing it to turn the valve to an invalid position.
Send the appropriate contact signal or GSIOC command.
5
Advertisement
Table of Contents
