Checking The Baud Rate - Gilson VALVEMATE User Manual

Installation

Checking the Baud Rate

Use the baud rate parameter to set rate for data
communication between the VALVEMATE and a
controlling device.
To modify the baud rate:
1 If necessary, turn on the VALVEMATE.
2 Press the MODE key until you see the following
message on the display:
Baud Rate: External
If the VALVEMATE is controlled via the RS-232,
change the baud rate to the value set for the
controlling device. Valid baud rates are 9600 and
19200. Do not use External.
If the VALVEMATE is controlled via the GSIOC,
make sure External is selected because the rate of
transmission is clocked outside of the VALVEMATE.
For example, if you connected the VALVEMATE
to a 506C System Interface, choose External for
the baud rate.
3 Press the MODE key to save the change.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2
2-11