Table of Contents
Advertisement
Installation
2-6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Making connections
To prepare the cable for each connection, do the
following:
1
Cut the cable into pieces of appropriate length;
then strip about 0.25 cm of insulation from each
end.
2
Insert each wire into the appropriate slot on the
terminal block connector. Push each wire all the
way in; then tighten its corresponding pin
screw.
Note: Be sure to maintain the correct orientation
of the terminal block connector relative to its
receptacle on the rear panel.
Attach all wires before joining the terminal
block connector to its receptacle.
3
Insert the terminal block connector into its
receptacle with the wires facing up and the pin
screws facing away from the device. Push the
connector in as far as it will go. It fits snugly
into its receptacle.
4
Connect the opposite ends of these wires to the
appropriate peripheral equipment. Be sure to
match
connections.
GND
2
Advertisement
Table of Contents
