4
Maintenance
The VALVEMATE module was designed to require minimal maintenance. However, if
you need to change the fuse(s), follow the instructions in this section.
If the installed valve should require maintenance, please refer to the instruction sheet
supplied with the valve.
Note: If a Rheodyne 5000-series valve is installed in the VALVEMATE, check and if necessary
tighten the screws located on the front of the valve before each run. These screws may loosen
over time causing fluid to leak.
4-1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com