Installing The Suse Driver In A New Linux System - Adaptec SATA RAID FOR Manual

5 When the Red Hat Welcome screen appears, type expert or
linux dd at the boot prompt.
6 When prompted, insert the driver disk (see
OK.
7 Follow the prompts to set up your preferred environment.
8 If you intend to install other third-party devices, proceed with
the installation of those devices. Otherwise, select Done.
9 Continue with the Linux installation according to the Red Hat
documentation.

Installing the SuSE Driver in a New Linux System

In this scenario, you are installing the driver in a new SuSE Linux
system. To install the driver:
1 Create a driver disk by following the instructions from the Web
site or the product CD.
2 Restart the computer.
3 If creating an array, press Ctrl+A when prompted to enter the
ARC utility. For instructions on creating an array from the BIOS,
see Chapter 5, Adaptec RAID Configuration
4 When the array is finished building, insert the SuSE CD Disk 1
in the CD-ROM drive then restart the system.
5 When the SuSE Installation menu appears, press the F3 key,
then select installation option from the Menu then press Enter.
6 When prompted, insert the driver disk you created (see
then press any key to continue.
7 Follow the prompts to set up your preferred environment.
8 Continue with the Linux installation according to the SuSE
documentation.
Installing the Driver
Step 1) then select
Utility.
Step 1)
2-4