Attaching A Disk Drive To A Drive Carrier; Installing Disk Drives - Adaptec DuraStor 7220SS Installation And User Manual

DuraStor 6220SS/7220SS Installation and User's Guide
6 Secure the left side rail to the vertical member using the screws
and nuts.
7 Repeat steps 6 and 7 for the other side rail.
Note: Be sure that the enclosure is level. Check that you
used mounting slots of the same height.

Attaching a Disk Drive to a Drive Carrier

1 Place the disk drive component-side down on a flat surface,
with the SCSI connector facing away from you.
2 Slide the drive carrier over the disk drive so that the handle of
the drive carrier curves down and is facing you. See
3 Attach the drive carrier to the disk drive using six screws, three
on each side of the drive carrier.

Installing Disk Drives

1 Align the drive carrier rail with the grooves in the drive bay. See
Figure 3-9.
Figure 3-9 Installing a Disk Drive
3-10
Figure 3-9.