Table of Contents
Advertisement
DuraStor 6220SS/7220SS Installation and User's Guide
Stand-Alone Single-Port Mode
This operating mode is a low-cost entry-level RAID storage
solution. Use this mode for maximum storage capacity with a
single host computer. In this mode, the Host In (CH 3) port
becomes a disk channel, providing additional storage capacity.
1 Connect the SCSI data cables as shown in
DuraStor SCSI RAID Appliance
Figure 3-16 Stand-alone Single-port Cabling Diagram
Note: External terminators are not required for any
stand-alone configuration.
2 Set the host system HBA to SCSI ID 7. Refer to your host
system's user's guide for details on setting HBA SCSI IDs.
3 Power on the DuraStor Storage Subsystem. See
page
3-54.
4 Set the controller operating mode. For detailed instructions,
refer to the user's guide for the storage management tool you
are using.
3-18
Host Computer
Figure
HBA 1
(ID 7)
3-meter
Cable
HOST 1 IN (CH 3)
HOST 2 IN (CH 0)
HOST 1 OUT
Disk CH 2
Disk CH 1
Serial B
Serial A
HOST 2 IN (CH 0)
Powering On on
3-16.
HOST 2 OUT
Ext
Int
Advertisement
Table of Contents
