Table of Contents
Advertisement
4 Slide one of the rack's mounting rails into the slot on the left side
of the RAID appliance's back panel. See
Push the rail in until it fits the depth of the rack. The rail should
mate with mounting slots on the rack's rear vertical member and
make the appliance level and tight-fitting.
Rail Slot
Threaded Stud
GRAPHIC GOES HERE
Rear Rack Vertical
Screws
Figure 3-4 Attaching the Rails
5 Secure the left side rail to the rack's rear vertical member using
the screws and nuts.
6 Repeat steps 6 and 7 for the other side rail.
Note: Be sure that the RAID appliance is level. Check that
you used mounting slots of the same height on both sides
of the rack.
7 Reinstall the PSUs. See
page
5-5.
Installing the DuraStor Storage Subsystem
Nut
Nuts
Mounting
Slot
Replacing a Power Supply Unit on
Figure
3-8.
Mounting Rail
3-5
Advertisement
Table of Contents
