Klein 3000 Series Troubleshooting Manual page 35

SYSTEM 3000 OPERATIONS AND MAINTENANCE MANUAL
$PS1
System Ready.
NOTE: GPS set to com1 at 4800 baud.
An improper boot will hang the system, and you may have to configure the TPU.
After a "time out" period, you will be put into the edit mode for the TPU. You will now
be able to edit the boot parameters. Enter c to change parameters.
Type the new parameter after the current parameter. If there are any other
parameters not noted below, leave them as they are. Note: "?" will give you a help
menu, and entering "any key" before the boot sequence will put you in the edit mode.
boot device
unit number
processor number
host name
file name
inet on ethernet (e)
host inet (h)
user (u)
ftp password (pw)
flags (f)
target name (tn)
startup script (s)
Turn the TPU off and then back on, and watch the boot sequence again.
The Klein startup.ini file is used to set boot parameters. The following is a typical .ini
file.
set SONARTYPE 3000
set RANGE 2
set RESPDIV 15
set RESPFREQ 7
set DESPECKLESWITCH 0
L-3 Klein Associates, Inc.
: fei...Leave as is
: 0...Leave as is
: 0...Leave as is
: sonarclient...Name of your host PC as noted earlier
: \klein\vxWorks...Path to vxWorks on your computer
: 192.168.0.81...Address you give the TPU
: 192.168.0.82
: klein...User name as set up earlier
: klein...User password as set up earlier
: 0x0...Sets boot delay to 10
: VxTarget...Set as is
: \klein\startup.ini ..Location of startup.ini file
TROUBLESHOOTING GUIDE 4-31