Initial Inspection And Handling; Do's And Don'ts - Seametrics CT2X Instructions For Use Manual

GENERAL INFORMATION

Initial Inspection and Handling

Upon receipt of your smart sensor, inspect the shipping package for damage. If any damage is apparent, note the signs
of damage on the appropriate shipping form. After opening the carton, look for concealed damage, such as a cut cable.
If concealed damage is found, immediately file a claim with the carrier.
Check the etched label on the sensor to be sure that the proper range and type were provided. Also check the label
attached to the cable at the connector end for the proper cable length.

Do's and Don'ts

Do handle sensor with
care
Don't drop into well
Lower gently to prevent
damage
Seametrics • 253.872.0284
  
  
Do store sensor in a
dry, inside area when
not in use
Don't scrape cable
over edge of well
May nick or fray the
cable
Do install a desiccant
tube if using a gauge
sensor
Don't bend cable sharply
May close off vent tube
and/or weaken internal
wires
Page 6
CT2X INSTRUCTIONS
  
  
Do install sensor so the
connector end is kept
dry
Don't support sensor
with the connector
Use a strain relief device
seametrics.com