List Of Errors And Advisory Messages - Bayer HealthCare Clinitek Status Operator's Manual

7 Troubleshooting
Lists of Errors and Advisory Messages
Clinitek Status Analyzer:
Error Code
E01
E10 or E48
E11
E23
E24
E25,
E64 or
E65
E27
7-4

List of Errors and Advisory Messages

Description
Low battery power
Loss of test results
Failure of test table
Low battery power
No printer paper
Failure of automatic
calibration
Set Up failure
Action
Replace the batteries: a) To view instructions
on the display, touch the Error Report selection
area, or b) To use the instructions in this
manual, see page 9-7, Changing Batteries.
1. Switch the instrument off by pressing the
on/off button for 2 seconds. 2. Switch the
instrument on again by pressing the on/off
button. 3. Repeat the test.
1. Make sure that the test table is in place.
Move the test table in or out of the instrument
slightly to reposition the test table. 2. If the
error remains, with the instrument powered
on, unplug the power cord from rear of
instrument and plug back in. Turn instrument
on by pressing the gray power button. 3. If the
error remains with the test table in place,
contact your local Bayer Customer Service
and Support Centre (contact information is
given in Appendix A).
Replace the batteries: a) To view instructions
on the display, touch the Error Report
selection area, or b) To use the instructions in
this manual, see page 1-2, Installing Batteries
and/or page 9-7, Changing Batteries. If the
battery level becomes too low to power the
instrument, Error Code E01 will be displayed.
Replace the printer paper a) See instructions
on the inside of the printer paper compartment
cover, or b) To view instructions on the display,
touch the Error Report selection area, or c) To
use the instructions in this manual, see page
1-4, Loading the Printer Paper or Label Roll.
Clean the calibration strip. If the error remains
after cleaning, contact your local Bayer
Customer Service and Support Center
(contact information is given in Appendix A).
1. Switch the instrument off by pressing the
on/off button for 2 seconds. 2. Switch the
instrument on again by pressing the on/off
button.
132387 Rev. B, 2004-10