Table of Contents
Advertisement
PC 2150 15.0" All-in-One PANEL PC User's Manual
2.
Another 6 screws, located on the upper perimeter (3) and
lower half (3), needs to be removed. These screws are the
screws bolting the system's rear cover to the main unit.
You may now take off the system's rear cover (along with
3.
the riser card assembly).
4.
Remove the HDD holders.
5.
Slide the CD-ROM to the Holder and fasten by two screws on
both sides.
6.
Slide the CD-ROM Holder to the Panel1150 and fasten the hold
to the chassis by two screws.
7.
Connect the FPC Cable to both CD-ROM and the I/O board. (as
the following figure)
8.
After completing the installation, restore the system back to its
original form by following instructions 3 to 1.
Connection to CD-ROM
System Installation
Connection to I/O Board
17
Advertisement
Table of Contents
