Riser Card Assembly - Acnodes PC 2150 User Manual

PC 2150 15.0" All-in-One PANEL PC User's Manual
3.9

Riser Card Assembly

The PC 2150 can be equipped with an optional riser card for
PCI or ISA slots expansion. There are 2 riser card options available
for PC 2150, 1PCI/2ISA or 2PCI/2ISA.
assembly directly plugs its riser card onto the PISA slot on SBC83675.
This makes the PC 2150 flexible for versatile applications.
When no riser card assembly is needed, a metal cover is placed on
the PISA slot opening.
The riser card assembly is made up of two sections: the main cabinet
and the cover. The main cabinet has 3 internal and 3 external screws
that secure the cabinet tightly on the PC 2150. The cover on
the other hand, also has 6 screws that hold it to the main cabinet, 3 on
each side.
The riser card assembly can accommodate both half-size and/or
full-size expansion cards. To install the riser card and riser card
assembly onto the main unit, refer to the following figure and
instructions below:
1. Take off the rear cover of the riser card assembly by
pushing it sideways and then pulling it up, as shown by the
arrows.
2. There are 4 screw holes located at the bottom of the
assembly that indicate the riser card placement. Fasten the
riser card as shown in the figure.
3. Plug either an ISA or PCI card into the ISA or PCI slot on the
riser card and screw the expansion card to the metal
opening piece. All the connectors of the expansion card
will come out from the opening along the side for further
connection.
4. Plug the riser card into the onboard PCI and ISA slots.
5. Mount the riser card assembly onto the main system by
fastening 4 screws, working from within the riser card
assembly.
System Installation
The riser card
19