Table of Contents
Advertisement
XVME-212 Manual
August, 1989
2.1 INTRODUCTION
This chapter provides the information needed to configure the XVME-212 and to install
it in a VMEbus backplane card cage.
2.2 SYSTEM REQUIREMENTS
The XVME-212 is a double-high VMEbus compatible module.
properly installed in a VMEbus backplane cardcage. The minimum system requirements
for operation of the XVME-212 are one of the following (either A or B below):
A)
A host processor properly installed on the same backplane.
A properly installed controller subsystem. An example of such a control subsystem
is the Xycom XVME-010 System Resource Module.
B)
A host processor which incorporates an on-board controller subsystem.
2.3
LOCATION OF COMPONENTS RELEVANT TO INSTALLATION
The jumpers, switches, and connectors on the XVME-212 are illustrated in Figure 2-1.
\
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Chapter 2
INSTALLATION
-OR-
2-1
To operate, it must be
Advertisement
Table of Contents
Need help?
Do you have a question about the XVME-212 and is the answer not in the manual?