Table of Contents
Advertisement
2-8
< 2. Installation >
Hole punching tool for wiring
(supplied as accessory)
Figure 2.11 How to punch out the wiring hole
(2) Loosen two screws which are at front of terminal box and detach the cover.
(3) After detaching the nut from the cable gland of sensor cable, pull the cable into the terminal
box from sensor cable inlet hole.
Connect the sensor cable to the terminals.
After passing the cable through the nut, check the symbol on each core wire, then connect
each core wire to the corresponding terminal.
Figure 2.12
(4) Mount the cable gland in the cable inlet hole.
Put the nut in place, and screw it onto the main body sufficiently. At this time, loosen the cap
so that the cable is not twisted. After fixing the main body, tighten the cap to keep moisture
out of the equipment. However if the cap is screwed up too tight, the cable will be damaged.
F2.12.ai
Connecting Sensor Cable (In case of the PH8TBG)
F2.11.ai
< 2. Installation >
IM 12B7K1-02E
11th Edition : Dec.14,2018-00
2-8
Advertisement
Table of Contents
