Seco SBC-C90 User Manual page 54

Tx Termination
4.3.19 M.2 peripheral management submenu
Menu Item
M.2 Key E
Wifi on M.2
Bluetooth on M.2
M.2 Key B
WWAN on M.2
4.3.20 Network Stack configuration submenu
Menu Item
Network Stack
Ipv4 PXE Support
Ipv4 HTTP Support
Ipv6 PXE Support
Ipv6 HTTP Support
IPSEC Certificate
PXE boot wait time
Media detect count
4.3.21 AMD CBS submenu
Menu Item
NBIO Common options
FCH Common options
SBC-C90
SBC-C90 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: A.R. - Reviewed by C.M. Copyright © 2021 SECO S.p.A.
Disable (default) or enable 120 Ohm Rx termination.
Option available when selecting RS-422 mode.
Disabled / Enabled
Disable (default) or enable 120 Ohm Tx termination.
Options Description
Options available for devices on M.2 Key E
Disabled / Enabled Enable Wifi capabilities from Wifi M.2 card
Disabled / Enabled
Enable bluetooth capabilities from bluetooth M.2 card .
Options available for devices on M.2 Key B
Disabled / Enabled Enable WWAN capabilities from a WWAN M.2 card
Options Description
Enabled / Disabled Enables or disables UEFI Network Stack. When enabled, following menu items will appear
Enabled / Disabled Enables or disables IPV4 PXE Boot Support. If disabled, IPV4 PXE boot option will not be created
Enabled / Disabled Enables or disables IPV4 HTTP Boot Support. If disabled, IPV4 HTTP boot option will not be created
Enabled / Disabled Enables or disables IPV6 PXE Boot Support. If disabled, Ipv6 PXE boot option will not be created
Enabled / Disabled Enables or disables IPV6 HTTP Boot Support. If disabled, Ipv6 HTTP boot option will not be created
Enabled / Disabled Enables or disables IPSEC certificate for Ikev
[0..5] Wait time to press ESC key to abort the PXE boot
[1..50] Number of times that the presence of media will be checked
Options Description
See submenu NorthBridge IO Configuration Options
See submenu Firmware Controller Hub Configuration options
54