Installation; Mounting The Raven Radar Speed Sensor - Raven SCS 660 Installation And Service Manual

INSTALLATION

1.

MOUNTING THE RAVEN RADAR SPEED SENSOR

See Appendix 8 for Wheel Drive Speed Sensor installation instructions.
See Appendix 9 for Speedometer Drive Speed Sensor installation instructions.
For mounting the Radar, the following guidelines will assure proper installation:
It is suggested that a large heavy mounting bracket, (P/N 107-0159-693) be attached
to the vehicle frame for mounting the Radar.
1) Park vehicle on level surface.
2) Select mounting site by considering the following:
a) The line of sight from the lens to the ground must not be obstructed by
structures or tires.
the bottom of the Radar.
b) The Radar lens must be parallel to the ground from front to back.
can be tilted out 0-15 degrees to provide more clearance and miss
obstructions. See Figure 2.
c) The Radar should be mounted so that the length of the Radar is parallel with
direction of vehicle travel.
3) Use carpenters level to verify that mounting bracket is parallel to the ground.
4) Bolt mounting bracket to implement.
Bolt Radar to mounting bracket using mounting hardware.
5)
6) Connect Radar with Radar Interface Cable (P/N 115-0159-539) to the Console. The
Red wire should be connected to the Orange cable wire. The White wire should be
connected to the negative terminal of the battery.
CAUTION: The connection of the Radar power in reverse polarity could result
in damage to the Radar.
Obstructions must not come closer than 20 inches to
FIGURE 1
See Figures 1 and 2.
FIGURE 2
FIGURE 3
4
See Figure 3.
See Figure 10.
Radar