Raven SCS 660 Installation And Service Manual page 29

14) BAUD RATE
A) RATE display will show "bAUd".
B) Depressing
"9600".
C) Momentarily depress
15) DATA LOGGER TRIGGER VALUE
A) RATE display will show "TriG".
B) Enter the TRIGGER VALUE.
C) Momentarily depress
NOTE: The TRIGGER VALUE default value is "zero".
to a desired number ranging from 1-9999. The DATA LOGGER features will
not work if this number is not changed.
16) DATA LOGGER TRIGGER UNITS
A) RATE display will show "UniT".
B) Depressing
and "SEC". A value of "FT"["nETr"] means feet [meters], or a value of "SEC"
means seconds have been chosen as the unit of measurement for the TRIGGER
VALUE programmed previously.
Momentarily depress
C)
DATA display will show "1200".
momentarily changes the DATA display between "1200" and
to advance to DATA LOGGER TRIGGER VALUE.
DATA display will show "0".
to advance to DATA LOGGER TRIGGER UNITS.
DATA display will show "FT"["nETr"].
momentarily changes the DATA display between "FT" [nETr"]
to advance to DATA LOGGER.
27
This value must be change