Installation Mounting Clearance - GE Fuji Electric MICRO-SAVER AF-300 Instructions Manual

S e c t i o n 3
INSTALLATION
Install the Drive in an indoor location that meets the
following requirements:
cover when the temperature exceeds +40" C
the Drive would come In contact with water.
dust, corrosive gas, Inflammable gas, or oil mist.
1000 meters (3281 feet). For installation above 1000
meters (3300 feet) the Drive will need to be derated
1% per 333 feet.
Example: 5 HP, 460 Vat,
Application altitude 3900 feet.
% derate = (3go&~300)
(9 amps) x ( w) = 8.84 amps
derated output current.
Motor derate may also be required,
contact motor manufacturer.
CAUTION:
B e c a u s e t h e a m b i e n t t e m p e r a t u r e g r e a t l y
affects Drive
a n y locatlon t h a t e x c e e d s t h e a l l o w a b l e t e m p e r a t u r e s .
ENVIRONMENT
between -10" C and
IS
(Remove the ventlla-
between 20% and 90%.
IS
output current 9 amps.
x 1% = 1.8%
d o n o t i n s t a l l t h e Drive in
2 "
Figure 3-1.
DRIVE MOUNTING CLEARANCE
INSTALLATION MOUNTING
CLEARANCE
ment, walls, or wiring ducts as shown in Figure
3-1 (these clearances are required to allow the
heat generated by the Drive to escape).
with the lettering right side up. (If the Drive is
installed upside-down or horizontally, heat build-
will
up occur )
size for weight of Drive.
location of mounting holes.
plate, install the rubber bushings supplied to pre-
vent cable damage and to mmimlze
CAUTION:
The mounting wall for the Drive must be
c o n s t r u c t e d o f h e a t r e s i s t a n t m a t e r i a l b e c a u s e d u r i n g
t h e t e m p e r a t u r e o f t h e D r i v e s c o o l i n g f i n s
NOTE:
When instaii/ng
and install them In a horizontal
must be prowdedbetween
baffle should be provided to prevent the
I
a m b i e n t t e m p e r a t u r e f r o m
2 "
o r m o r
5 " o r m o r e
3-l
dust entry.
F).
two or more Drives in close
space as shown in Figure 3-1
row. if they must be
each one