GE Fuji Electric MICRO-SAVER AF-300 Instructions Manual page 43

Control Circuit Connection and Operation (cont'd)
2. Common termrnal connection example regardless of operatron
3 0 A
(SPDT contact) is output This is used for alarm circuits etc.
F M P . . . . . . . . Used when the frequency is to be displayed with an external digital counter.
NOTE: Simultaneous use of FMA and FMP
(Function Code 28.)
THR . . . . . . . . . . . . . . . At the time of shipping, this
an external fault signal, connect a NC (normally closed) contact.
RST/BX..... Connect the NO (normally open) contact signal to reset a fault condition, or coast stop the motor.
RUN . . . . . . . . . . . ..When the Drive is running, the open collector transrstor output
3 Operation through keypad panel (for F-02 = _ _ _ 0)
3 0 A
a. The connection of the common terminals is the same as explained in #2 above.
b The direction of rotation is forward when FWD is connected to CM, and reverse when REV is
connected to CM.
c. To set the frequency, either of the followrng
Code F-01.
plus side) and the DC voltage signal of DC 0 to +lO V between terminals 12 and 11 (12 is
plus polarity.)
A n a l o g f r e q u e n c y
R Y
m e t e r
RUN FMA NC
NC
FMP X2 X3
to be disdplayed with an external analog meter
IS
connected to the terminal CM. When the Drive
IS
RUN FMA NC NC RST/BX
FMP Xl X2
two methods can be selected by using Functron
5-11
method.
Cl 13 12
REV FWD THR CM
I
not possible, and only one should be selected
IS
turned on
IS
Cl 1 3 1 2
I
11
I
to be stopped by
IS
1 1